AOR AR2000 Manuale Utente Scaricare il pdf (Pagina 52)

The Strap/Belt Clip

The strap/belt clip

The AR1000 comes with a strong metal belt clip that allows you to clip the

scanner on your belt. While most people will take advantage of this clip, if you

will not be using it, you may want to remove it. By removing the belt clip, the

unit will be less bulky and will go in and out of the carrying case significantly

easier.

The AR1000 also has two lugs at the top of the unit that are used for hooking on

the shoulder strap. If you decide that you don’t want to use the shoulder strap,

you may want to reverse these “Frankenstein” lugs. The unit will be sleeker and

this will also make getting the scanner in and out of the carrying case much

easier.

The belt clip is held on by two Phillips screws and is very easy to remove. Just

unscrew the screws and keep them in a safe place, in case you want to re-install it.

Put a piece of clear tape over the holes to keep out dirt. Alternatively, if you don’t

mind the extra protrusion, just screw the screws back into the holes on the unit.

You will want to reverse the strap lugs rather than remove them because you will

be left with two open holes in the case if you simply remove them. The lugs are

asymmetrical, so when you reverse them they lay flush with the case.

First open the case by removing the four Phillips screws that hold the case to-

gether. Two are just below the strap lugs in the back and the other two are at the

bottom of the battery compartment.

After removing the screws, separate the back of the case. You will then be able to

slip the silver strap lugs out of their slots. Reverse them and place them back in

the slots so that they lay flush with the side of the case. The lug on the side of the

antenna connector may press against the antenna terminal inside the case. It is a

good idea to put a small piece of electricians tape against the antenna terminal

before reversing this lug, to insulate it from making direct contact with the

antenna terminal.

Be aware that opening the case of the AR1000 may void your warranty.

To reverse

the strap

lugs

To remove

the belt clip

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 90 91

Nessun commento

AOR AR2000 Manuale Utente Pagina 52