AOR AR2000 Manuale Utente Scaricare il pdf (Pagina 70)

PROG

The PROG button is used to program in scan bank limits and search bank

limits. It is also used to lock and unlock individual frequencies within a search

bank and to lock and unlock entire search banks. You can also use it to program

a specific scan channel with a frequency, but we don’t recommend you use this

method. See page 16 for a discussion of the different ways to program a scan

channel.

The PROG button is always used with other buttons in a sequence.

INC

The INC button is used primarily to set a search increment when setting up

search bank limits. Once you choose a lower and upper frequency range, you tell

the scanner to scan the range in a certain size jump. This jump is the search

increment. It is specified in kilohertz (KHz), not megahertz.

The INC button has no meaning while in Scan mode, so it doesn’t do anything.

You will normally use it while programing a search bank limit and will be

prompted for an increment value when the KHz indicator flashes in the display.

But you can use the INC button to change the increment of an existing search

bank. Say you set up search bank 4 to search through 60 MHz to 70 MHz in 5

KHz increments. While searching bank 4, you can press the INC button. You

will be prompted with a flashing KHz in the display and may then enter in a new

search increment, say 100 KHz. Bank 4 will now use the 100 KHz increment for

its search. All the other search parameters for bank 4 stay the same.

In Manual mode you can modify the frequency of the scan channel you are

looking at by pressing the Down arrow button or by using the Tuning knob. The

current frequency will increase or decrease (depending on which way you turn

the knob or if you are using the Down arrow) by a default of 12.5 KHz. By

pressing the INC button and entering a different increment, you can change the

step that these controls will use (if the frequency you enter ends in .5KHz, as in

6.1275, the scanner will automatically default to a 5 KHz increment).

For example, say you are in Manual mode looking at Scan channel 731. It

contains the frequency 9.600 MHz in AM mode. You have a long wire attached

as an antenna, since you are trying to receive shortwave transmissions. You can

move up or down from this frequency by turning the Tuning knob. If you turn it

one click to the right, the scanner will change to 9.6125 MHz. One click to the

left would have changed it to 9.5875 MHz. By pressing INC, 5, ENT, you

change the increment value to 5 KHz instead of 12.5 KHz. Then, from 9.600

MHz, one click to the right of the Tuning knob will change the frequency to

9.605 MHz.

The Keyboard

1 2 ... 65 66 67 68 69 70 71 72 73 74 75 ... 90 91

Nessun commento

AOR AR2000 Manuale Utente Pagina 70