AOR AR5001D Guida Utente Scaricare il pdf (Pagina 48)

SignalTrack User's Guide

Press the Load Map Files button and load using the standard file dialog select the maps you are

going to use. You can always add or delete maps or change the map menu at a later time using the

Map Menu Builder. However, it will be helpful to at least load one map that will display your

current location. After you loaded the maps, press Next and the following dialog will appear.

Enter the frequency and name of all channels that you may frequently monitor and press Finish. It is

not necessary to enter any channels at this time. Channels can always be added later using the

Channels menu.

After you press finish a Save As dialog will be displayed. Type in a name for the mission and press

Save.

If you have a compass installed, shortly after pressing Save you should see a triangle appear on the

map near your present location. The exact amount of time it takes to display your location will

depend on the convergence time of the GPS receiver which can be a few minutes depending on your

location and weather conditions. If you do not have a compass installed it may be necessary to drive

a short distance to allow the GPS to establish a heading. If after a short time you do not see your

position displayed go to the Trouble Shooting section.

Figure 20: Press Load Maps and Select All the Maps You Will Be Using

Figure 21: Enter any Frequently Used Frequencies

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 119 120

Nessun commento

AOR AR5001D Guida Utente Pagina 48