AOR AR5001D Guida Utente Scaricare il pdf (Pagina 57)

Using SignalTrack

SCANNING SAVED CHANNELS

When using SignalTrack at a fixed site or at a Network Control Site, it can be programmed to

perform simple channel scanning. To enable scanning select Options from the Setup menu and

press the Scan tab. Check the Time to monitor channel during scan check box and then

select the type of scan you wish to use. Two types of scanning are available. The first option is to

set a time to dwell on a channel while a bearing is being displayed (see timing diagrams below).

When this setting is used SignalTrack will monitor channels that have no signals on them for the time

set in the Time to monitor channel during scan and monitor channels with signals for Time to

dwell on channel when receiving bearing. If the second option is selected, SignalTrack will

monitor channels that have no signals on them for the time set in the Time to monitor channel

during scan and will continuously monitor the first channel with a signal on it until the signal

disappears and the Time to linger on channel after signal disappears elapses. The channels

that are scanned are the enabled channels as setup in the Edit Channels (see "Channels" on page

49) dialog.

Figure 29: Scan Setup Dialog

Figure 30: Dwell on Channel for a Fixed Time

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 119 120

Nessun commento

AOR AR5001D Guida Utente Pagina 57