AOR AR5001D Guida Utente Scaricare il pdf (Pagina 71)

Using SignalTrack

When the run button is pressed, SignalTrack will play the audio being received from one of the sites.

You can use the Audio Monitoring dialog to select which site to listen to and to set audio

monitoring options. To display the Audio Monitoring dialog select View->Audio Monitoring to

display the dialog shown below.

To change the site you are monitoring select the site name from the

Site dropdown list.

The received audio from all sites will be recorded if any one site breaks the squelch setting. In most

cases the default setting will suffice provided that the receivers at the remote sites squelch when no

signal is on frequency. However, the squelch setting can be changed by adjusting the squelch level.

The Options menu can be used to adjust the Buffer time and the Squelch time. The Buffer time is

the time that SignalTrack receives audio before playing it. The buffer time results in a delay in the

audio and a small value is best; however, in some instances where the network has sporadic latency it

may be necessary to increase the buffer time as shown below

The Squelch time is the time SignalTrack keeps recording after the audio on all the channels drops

below the squelch level. To adjust this time select Option->Squelch Time and select the time you

would like to use as shown below.

Figure 42: Audio Monitoring Dialog

Figure 43: Setting the Audio Monitoring Buffer Delay

1 2 ... 66 67 68 69 70 71 72 73 74 75 76 ... 119 120

Nessun commento

AOR AR5001D Guida Utente Pagina 71