AOR AR5001D Guida Utente Scaricare il pdf (Pagina 59)

Using SignalTrack

SETTING UP RECEIVER MEMORY

If you are using an AOR5000 or an ICOM R8500 receiver, you can use the receiver to scan a

number of frequencies and direction find on a signal found by the receiver. Both receivers have a

number of memory locations organized in banks. The ICOM receiver has 20 banks with 40 channels

each, the AOR receiver has 10 banks with 100 channels per bank.

To set up a receiver for scanning from SignalTrack you must first select a control site. The

frequency that the control site is tuned to will determine the frequency the network will monitor.

When the control site detects a signal, SignalTrack reads the frequency of the receiver and then sets

the frequency of all the sites on the network to the control site frequency. This feature can be used

when the receiver is scanning or it can also be used when a local operator is manually tuning the

receiver. To set the control site select the RX Memory->Control Site from the tool bar as

shown below

Once you've selected the control site you can either scan memory banks that have been previously

programmed into the receiver or you can program the receiver memories.

To program the receiver memories, select Edit RX Memories from the RX Memory tool bar

dropdown menu. The following dialog will be shown.

Figure 32: Select the Site You want to be the Control Site

1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 119 120

Nessun commento

AOR AR5001D Guida Utente Pagina 59